![]() This manual comes under the category Servers and has been rated by 1 people with an average of. Do a full backup before using the Factory Default option. View the manual for the Netgear ReadyNAS 214 here, for free. Memory test ongoing, Disk LEDs indicate pattern number is under testing. Warning: Using the Factory Default boot menu option will erase all the data on the hardĭisks. The system will reset to the factory default settings, and erase all the data on the disks. Press the SYS button at the back to confirm the menu selection and proceed to that option. Push the BACKUP button on the front panel two times to scroll through the menu to theįactory Default option (USB LED off, Disk 1 LED off, Disk 2 LED on, Disk 3 LED off, Disk 4 LED off).Ĥ. The LEDs will indicate the reset menu is active.ģ. To 30 seconds for the reset menu on the front to display, then release the reset switch. While using a paper clip or push pin to press in the SYS switch, power on the unit. To reconfigure your RAID setup, complete the following steps:Ģ. I soon will be receiving a ReadyNAS 3100 for personal/home use. This manual comes under the category Servers and has been rated by 2 people with an average. The device remains in the selected mode until explicitly changed. View the manual for the Netgear ReadyNAS Ultra 4 here, for free. ![]() It is not necessary to perform this procedure every time you boot up the system. You can switch between the X-RAID2 (Expandable Volume) mode and the Flexible Volume (Flex- RAID 0/1/5 mode only if you want to change the default configuration. Using the Boot Menu to Format a RAID Volume Optimizing Performance and Maintaining the System ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |